package
0.0.0-20211205205814-168ccc21e67c
Repository: https://github.com/ziutek/emgo.git
Documentation: pkg.go.dev
# Constants
+ Acknowledge Enable.
+ Bit 0.
Bit 1.
+ Interface Address.
+ 10-bit header sent (Master mode).
Bit 2.
Bit 3.
Bit 4.
Bit 5.
Bit 6.
Bit 7.
Bit 8.
+ Interface Address.
Bit 9.
+ Addressing Mode (Slave mode).
+ Address sent (master mode)/matched (slave mode).
+ Acknowledge Failure.
+ SMBus Alert.
+ Analog Noise Filter OFF.
+ Arbitration Lost (master mode).
+ Bus Error.
+ Byte Transfer Finished.
+ Bus Busy.
+ Clock Control Register in Fast/Standard mode (Master mode).
+ DMA Requests Enable.
+ Digital Noise Filter.
+ Dual Flag (Slave mode).
+ Fast Mode Duty Cycle.
+ ARP Enable.
+ Dual addressing mode enable.
+ General Call Enable.
+ PEC Enable.
+ FREQ[5:0] bits (Peripheral Clock Frequency).
+ I2C Master Mode Selection.
+ General Call Address (Slave mode).
+ Buffer Interrupt Enable.
+ Error Interrupt Enable.
+ Event Interrupt Enable.
+ DMA Last Transfer.
+ Master/Slave.
+ Clock Stretching Disable (Slave mode).
+ Overrun/Underrun.
+ Peripheral Enable.
+ Packet Error Checking.
+ PEC Error in reception.
+ Packet Error Checking Register.
+ Acknowledge/PEC Position (for data reception).
+ Data Register not Empty (receivers).
+ Start Bit (Master mode).
+ Interface address.
+ SMBus Alert.
+ SMBus Device Default Address (Slave mode).
+ SMBus Host Header (Slave mode).
+ SMBus Type.
+ SMBus Mode.
+ Start Generation.
+ Stop Generation.
+ Stop detection (Slave mode).
+ Software Reset.
+ Timeout or Tlow Error.
+ Transmitter/Receiver.
+ Data Register Empty (transmitters).