package
0.0.0-20211205205814-168ccc21e67c
Repository: https://github.com/ziutek/emgo.git
Documentation: pkg.go.dev
# Constants
+ 10-bit addressing mode (master mode).
+ Address match code (slave mode).
+ Address matched (slave mode).
+ Address matched clear flag.
+ Address match interrupt enable.
+ SMBus alert.
+ Alert clear flag.
+ SMBus alert enable.
+ Analog noise filter OFF.
+ Arbitration lost.
+ Arbitration lost clear flag.
+ Automatic end mode (master mode).
+ Bus error.
+ Bus error clear flag.
+ Bus busy.
+ Transfer direction (slave mode).
+ Digital noise filter.
+ Errors interrupt enable.
+ General call enable.
+ 10-bit address header only read direction (master mode).
+ NACK generation (slave mode).
+ NACK clear flag.
+ NACK received flag.
+ NACK received interrupt enable.
+ Number of bytes.
+ Clock stretching disable.
+ Interface own address 1.
+ Own address 1 enable.
+ Own address 1 10-bit mode.
+ Interface own address 2.
+ Own address 2 enable.
OA2[1] is masked, Only OA2[7:2] are compared.
OA2[2:1] is masked, Only OA2[7:3] are compared.
OA2[3:1] is masked, Only OA2[7:4] are compared.
OA2[4:1] is masked, Only OA2[7:5] are compared.
OA2[5:1] is masked, Only OA2[7:6] are compared.
OA2[6:1] is masked, Only OA2[7] are compared.
OA2[7:1] is masked, No comparison is done.
+ Own address 2 masks.
No mask.
+ Overrun/Underrun.
+ Overrun/Underrun clear flag.
+ Peripheral enable.
+ PEC register.
+ Packet error checking byte.
+ PAC error clear flag.
+ PEC enable.
+ PEC error in reception.
+ Timings prescaler.
+ Transfer direction (master mode).
+ NBYTES reload mode.
+ 8-bit receive data.
+ DMA reception requests enable.
+ RX interrupt enable.
+ Receive data register not empty.
+ Slave address (master mode).
+ Slave byte control.
+ Data setup time.
+ SCL high period (master mode).
+ SCL low period (master mode).
+ Data hold time.
+ SMBus device default address enable.
+ SMBus host address enable.
+ START generation.
+ STOP generation (master mode).
+ STOP detection clear flag.
+ STOP detection flag.
+ STOP detection interrupt enable.
+ Software reset.
+ Transfer complete (master mode).
+ Transfer complete interrupt enable.
+ Transfer complete reload.
+ Extended clock timeout enable.
+ Idle clock timeout detection.
+ Timeout or Tlow detection flag.
+ Bus timeout A.
+ Bus timeout B.
+ Timeout clear flag.
+ Clock timeout enable.
+ 8-bit transmit data.
+ DMA transmission requests enable.
+ Transmit data register empty.
+ TX interrupt enable.
+ Transmit interrupt status.
# Variables
emgo:const.