As you congratulate yourself for a job well done, you notice that the documentation has been on the back of the tablet this entire time. While you actually got most of the instructions correct, there are a few key differences. This assembly code isn't about sound at all - it's meant to be run twice at the same time.

Each running copy of the program has its own set of registers and follows the code independently - in fact, the programs don't even necessarily run at the same speed. To coordinate, they use the send (snd) and receive (rcv) instructions:

snd X sends the value of X to the other program. These values wait in a queue until that program is ready to receive them. Each program has its own message queue, so a program can never receive a message it sent. rcv X receives the next value and stores it in register X. If no values are in the queue, the program waits for a value to be sent to it. Programs do not continue to the next instruction until they have received a value. Values are received in the order they are sent. Each program also has its own program ID (one 0 and the other 1); the register p should begin with this value.

For example:

snd 1 snd 2 snd p rcv a rcv b rcv c rcv d Both programs begin by sending three values to the other. Program 0 sends 1, 2, 0; program 1 sends 1, 2, 1. Then, each program receives a value (both 1) and stores it in a, receives another value (both 2) and stores it in b, and then each receives the program ID of the other program (program 0 receives 1; program 1 receives 0) and stores it in c. Each program now sees a different value in its own copy of register c.

Finally, both programs try to rcv a fourth time, but no data is waiting for either of them, and they reach a deadlock. When this happens, both programs terminate.

It should be noted that it would be equally valid for the programs to run at different speeds; for example, program 0 might have sent all three values and then stopped at the first rcv before program 1 executed even its first instruction.

Once both of your programs have terminated (regardless of what caused them to do so), how many times did program 1 send a value?